Quote:
|
Originally Posted by Martian
I'm still not clear.. couldn't you just do above and run the connector out through an open card slot in the back of the case?
|
Well, I could... but that would be ugly
. That's the only reason, but for me it's reason enough to avoid that solution. I mean, it's a custom case, here. I don't want it to look
too amateur.
Quote:
|
Originally Posted by flat5
don't some segment drivers have an enable pin?
|
Not that I'm aware of, but that doesn't mean they don't exist. I'll look into that.
Quote:
|
Originally Posted by flat5
I would run this to a cmos comparator.
|
Eh? I haven't used a comparator before, so I'm not entirely sure what they do. If I understand it correctly, they work as an interface for an external sensor... would I use that to control the pulsing of the LEDs when connected to the audio source?